Download or read book QA/QC of Subgrade and Embankment Construction written by Eshan Ganju and published by . This book was released on 2015-09-01 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The Dynamic Cone Penetrometer (DCP) is a device that is used for the estimation of in situ compaction quality of constructed subgrades and embankments. It is a relatively inexpensive, light-weight and easy to use device that measures the dynamic penetration resistance of the compacted soil, from which an estimate of soil strength and stiffness characteristics can be made. Owing to its ease of use, many DOTs in the U.S. have employed the DCP in their compaction quality control procedures, and over the past few decades, extensive research has been carried out on the development of correlations between the results of the DCP test and the results of strength and stiffness tests performed on compacted soils (e.g., California bearing ratio, and resilient modulus)The objectives of this research are to refine DCP-based quality assurance and quality control correlations for compaction quality control developed by previous research studies carried out at Purdue for the Indiana Department of Transportation, especially focusing on (1) grouping of the soils based on their mechanical response to the DCP loading, and (2) limiting the in situ moisture range of the soils used for development of correlations within -2% of the optimum moisture content of the tested soil. The factors outlined above are studied, and in particular, soil grouping is examined critically. The AASHTO ('A-based') classification employed previously for classification of soils is replaced with a new classification criteria specifically developed for the DCP test. Soils are grouped into one of the two categories of coarse-grained or fine-grained soils on the basis of the size of the dominant particle in the soil. The criteria developed for the classification of soil into one of these two categories is based on index properties of the soil, such as the standard Proctor maximum dry density, optimum moisture content, plasticity index (PI) and fines content.